Home » HBM-604B-UL Driver Card
Itoh Denki

HBM-604B-UL Driver Card

SKU: HBM-604B-UL
Please contact us for assistance with part number configuration and compatibility at 704-519-4661 or fill out a Request for Quote below
Ordering Variants

Output type must be specified when ordering. Select a variant below for details and pricing.

The Itoh Denki HBM-604B-UL is a 2-zone ZPA hybrid driver card with a 10 pin connector that controls up to 2 Power Moller® rollers (brake and non-brake models). It includes built-in Zero Pressure Accumulation logic, 2 sensor connections, daisy-chain communication between adjacent cards, and can handshake signals with the IB-E03B Ethernet/IP controller. Available in PNP output (HBM-604BP-UL) and NPN output (HBM-604BN-UL) — output type must be specified when ordering. Non-brake model rollers must use a 10 pin motor connector.

Key Features

  • Controls up to 2 Power Mollers (brake and non-brake models)
  • 2 sensor connections that power and receive sensor output
  • Dynamic brake control
  • Stable speed function for consistent transfer across varying loads
  • Variable speed control by rotary switch
  • Motor direction control by onboard DIP switch
  • Built-in Zero Pressure Accumulation (ZPA) control logic
  • Flexible Zone Recognition for long articles spanning multiple sensors
  • Daisy-chain wiring between adjacent HBM-604B-UL cards
  • Can handshake signals with IB-E03B Ethernet/IP controllers

Operation

  • Continuous or intermittent duty
  • Minimum cycle: 1s ON; 1s OFF
  • Do not exceed 150% of no-load speed

Environment

  • Ambient temperature 32~104°F (0~40°C)
  • < 90% relative humidity (no condensation)
  • No corrosive gases
  • Vibration < 0.5G

Protection

  • Thermal overload 185°F (85°C) on PCB
  • Two 7A fuses (one per motor)
  • Input power protected against reversed polarity

Specifications

Connector 10 pin
Zones 2
Motor Control Up to 2 Power Mollers
Output Type PNP (HBM-604BP-UL) or NPN (HBM-604BN-UL) — must specify when ordering
Power Connector WAGO #231-302/026-000 (included)
Sensor Connector WAGO #733-103 (included)
External Control WAGO #733-106 (optional, not included)

Compatible Power Moller® Rollers

PM486FE 1.91" (48.6 mm) dia. — Standard torque, single shaft mounting, spring loaded shaft
PM486FP 1.91" (48.6 mm) dia. — High torque, dual shaft mounting, threaded hex shafts
PM486FS 1.91" (48.6 mm) dia. — Standard torque, dual shaft mounting
PM570FE 2.24" (57.0 mm) dia. — Standard torque, single shaft mounting
PM605FE 2.38" (60.5 mm) dia. — Standard torque, single shaft mounting
PM635FS 2.50" (63.5 mm) dia. — Heavy duty pallet handling, single shaft mounting

Specifications are subject to change without prior notice. Please contact us for assistance with driver card selection and compatibility.