Home » CB-016S7 Driver Card
Itoh Denki

CB-016S7 Driver Card

SKU: CB-016S7
Please contact us for assistance with part number configuration and compatibility at 704-519-4661 or fill out a Request for Quote below
Ordering Variants

The Itoh Denki CB-016S7 is a single-zone driver card with a 9 pin connector, designed for standard-torque Power Moller® DC rollers. It provides up to 20 speed settings through a DIP switch and rotary switch combination or external voltage input, with direction control, adjustable acceleration/deceleration (0 to 2.5s), and dynamic brake functionality. A snap-on cover enables easy NPN/PNP switching without removing the card from the frame. Available in PNP output (CB-016P7) and NPN output (CB-016N7) — output type must be specified when ordering.

Key Features

  • Simple operation
  • 3 LEDs to identify error type and occurrence count
  • Dynamic brake control
  • Stable speed function for consistent transfer across varying loads
  • Variable speed: DIP switch + rotary switch or external voltage input (up to 20 speeds)
  • Direction control by onboard DIP switch or external signal input
  • Adjustable acceleration and deceleration time (0 to 2.5s)
  • Manual or automatic recovery of thermal overload
  • Forcibly stops motor if lock or thermal error exceeds 4 seconds
  • Snap-on cover for easy NPN/PNP switching without removing from frame
  • Includes mounting hardware and wiring connectors

Operation

  • Continuous or intermittent duty
  • Minimum cycle: 1s ON; 1s OFF
  • Do not exceed 150% of no-load speed

Environment

  • Ambient temperature 32~104°F (0~40°C)
  • < 90% relative humidity (no condensation)
  • No corrosive gases
  • Vibration < 0.5G

Protection

  • Thermal overload 185°F (85°C) on PCB
  • 5A fuse to power supply
  • Diode protection for incorrect wiring

Specifications

Connector 9 pin
Speed Settings 20 (DIP switch + rotary switch or external voltage)
Output Type PNP (CB-016P7) or NPN (CB-016N7) — must specify when ordering
Dimensions 129 mm x 52 mm (5.08" x 2.05")
Power Connector WAGO #734-102 (included)
Control Connector WAGO #733-105 (included)

Available Options

  • Brake: CB-016BS7-UL (10 pin connector)
  • Low Temperature: CB-016S7-LT

Compatible Power Moller® Rollers

PM486FE 1.91" (48.6 mm) dia. — Standard torque, single shaft mounting, spring loaded shaft
PM486FP 1.91" (48.6 mm) dia. — High torque, dual shaft mounting, threaded hex shafts
PM486FS 1.91" (48.6 mm) dia. — Standard torque, dual shaft mounting
PM570FE 2.24" (57.0 mm) dia. — Standard torque, single shaft mounting
PM605FE 2.38" (60.5 mm) dia. — Standard torque, single shaft mounting
PM635FS 2.50" (63.5 mm) dia. — Heavy duty pallet handling, single shaft mounting

Specifications are subject to change without prior notice. Please contact us for assistance with driver card selection and compatibility.