Dorner 2200 iDrive Tail Kit for D position with Lagged Spindle — 22V2FDLD

Dorner 2200 iDrive Tail Kit for D position with Lagged Spindle for the Dorner 2200 Series idrive tail.

Key service part: Dorner identifies this part or kit as a key service item and recommends keeping applicable replacements on hand.

Selection and fit

This kit is for the D mounting position. Match the mounting position and spindle type to your existing iDrive tail.

Select your conveyor width above, then add the kit to your cart. The selected width determines the kit configuration; you do not need to select or add its included components separately.

Kit contents

Dorner identifies the following components for this kit.

• Lagged drive spindle assembly
• Drive head plate, D position
• Non-drive head plate, D position
• Flat-head screw, M6-1.00 x 16 mm
• Hex nut

Manual reference

View / download the Dorner 2200 conveyor manual (PDF) — page 63

Dorner 2200 Series Installation, Maintenance & Parts Manual, 851-816 Rev. G, page 63, iDrive Tail. Confirm your conveyor model and configuration before ordering.

Other key service parts shown below relate to the same assembly. Kit configurations are not necessarily interchangeable; check shaft style, spindle surface, mounting position and width before selecting.