Dorner 2200 Common Drive - Knurled Mid Conveyor Spindle Kit (Two Stub Shafts) — 22V2FC

Dorner 2200 Common Drive - Knurled Mid Conveyor Spindle Kit (Two Stub Shafts) for the Dorner 2200 Series end drive tail.

Key service part: Dorner identifies this part or kit as a key service item and recommends keeping applicable replacements on hand.

Selection and fit

Match the spindle surface and shaft configuration to your existing conveyor. The manual lists the square key under the included items for this kit; confirm supplied hardware if servicing a stub-shaft configuration.

Select your conveyor width above, then add the kit to your cart. The selected width determines the kit configuration; you do not need to select or add its included components separately.

Kit contents

Dorner identifies the following components for this kit.

• Left-hand head plate
• Right-hand head plate
• Common Drive - Knurled Mid Conveyor Spindle Assembly (Two Stub Shafts)
• Flat-head screw, M6-1.00 x 16 mm
• Square key, 4 mm x 28 mm

Manual reference

View / download the Dorner 2200 conveyor manual (PDF) — page 61

Dorner 2200 Series Installation, Maintenance & Parts Manual, 851-816 Rev. G, page 61, End Drive Tail. Confirm your conveyor model and configuration before ordering.

Other key service parts shown below relate to the same assembly. Kit configurations are not necessarily interchangeable; check shaft style, spindle surface, mounting position and width before selecting.